The Lumenis AcuPulse laser is a complete ablative laser resurfacing workstation that features superior technology for all aesthetic resurfacing needs, as well as some surgical technology. It allows us to perform a variety of procedures, including CO2 Skin Resurfacing, FemTouch Vaginal Rejuvenation, and a hand-piece for Surgical Blepharoplasty.
CO2 lasers produce light at a 10,600nm wavelength, which is absorbed by water in the tissue. The laser energy heats up the water until it reaches a boiling point causing the evaporation of the affected tissue. Some heat is absorbed by tissue adjacent to the ablated target area, causing tissue coagulation which induces hemostasis (the cessation of bleeding) as well as thermal stimulation of deep skin layers, which induces fibroblast stimulation and neocollagenesis (the formation of new collagen). The laser beam can also be transmitted through a scanner which is a device used to further control the delivery of energy. The scanner regulates the configuration of energy delivered onto the skin, which can range from covering the entire treatment area or just a fraction of it, leaving the areas in between untreated. This is also referred to as fractional ablation. The overall effect of ablation and coagulation, either full or fractional, is the removal of skin and the stimulation of the body to replace it with newer, younger skin.
Northwestern Med Spa offers the Lumenis® state-of-the-art CO2 laser device, the AcuPulse™. The AcuPulse system uses unparalleled high-power-short duration pulse technologies that maximize treatment effectiveness, safety and patient comfort, as well as minimize downtime and risk of complications resulting from treatments. Lumenis’ CO2 laser optimally treats a broad range of conditions from gentle superficial treatments to deep contracted scar revision.
This procedure can be used to effectively treat fine lines, wrinkles, and discoloration, as well as other effects of aging and sun damage. The laser beam is applied in a fraction pattern to create columns of thermal damage on the skin to stimulate new collagen. Columns are spaced out so that the remaining tissue is spared, resulting in faster healing.
Patients experience warmth, similar to sunburn, after treatment. During this time, a gentle washing and moisturizing regimen is recommended. Skin will then flake off within two days. After four to seven days, typically make-up be applied. Pinkness is often gone after about a week . Most effects of the treatment, such as the stimulation of new collagen and plumping of the skin occur right away. However, results will gradually continue to show improvement for up to six months after the procedure and can last for several years.